Free shipping above HUF 40,000 (gross)  ·  Professional customers only (B2B)  ·  Call us: +36 70 398 2552  ·  info@neximed.hu

Dental handpieces, contra-angles and turbines are among the most expensive instruments in a practice and are used every day. Their lifespan depends largely on whether the team consistently cleans, lubricates and sterilises them after each treatment. Regular maintenance not only reduces repair costs but also supports patient safety.

Immediately after treatment

At the end of treatment, before removing the bur or head, run the handpiece with water and air for a few seconds to flush debris out of the internal channels. Then wipe the outer surface with an alcohol-based disinfectant wipe approved by the manufacturer. Never immerse a handpiece in disinfectant solution unless the manufacturer explicitly allows it.

Internal cleaning and lubrication

Before sterilisation, the handpiece must also be cleaned and lubricated internally, using a dedicated handpiece oil spray or an automatic maintenance unit. Apply the oil through the connector specified by the manufacturer, then remove the excess by briefly running or blowing out the handpiece. Too little oil accelerates bearing wear, while too much can bake on during sterilisation.

Sterilisation

Common mistakes

The most frequent problems are skipped lubrication, incorrect air pressure, running without a bur and using damaged burs. If a handpiece becomes noisier, heats up, vibrates or the bur no longer locks securely, stop using it and send it for service. Having several handpieces per treatment unit leaves enough time for a complete maintenance cycle.

What you will need

You will find products for maintenance and sterilisation in the Disinfection & sterilization category, and handpieces and devices in Devices & equipment.

Frequently asked questions

How long does a dental handpiece last?

There is no single figure: the lifespan of a handpiece depends on how intensively it is used, on the model and above all on daily care. Cleaning and lubricating it after every patient, sterilising it exactly as the manufacturer instructs and having bearings or turbines serviced in time are what keep a handpiece working for longer.

How should a handpiece be sterilised?

Clean and lubricate the handpiece first, then sterilise it packaged in a steam steriliser, if the manufacturer marks it as autoclavable. Always follow the manufacturer’s instructions for use regarding temperature, cycle and lubrication before and after sterilisation.

What is the most common cause of handpiece failure?

Skipped or insufficient lubrication and residue left inside the handpiece before sterilisation. A fixed routine for the whole team helps avoid this.

More articles